06.05.2012, 14:35
Hi Trac enthusiasts,
I have Trac 800 (1975?) with a dead OM314 motor and have the opportunity to replace it with an OM 352 from a Class combine harvester. I have a few concerns regarding hydraulics and the air compresor. I can fit the hydraulic pump from the harvester but not sure how to plumb the power steering and rear hydraulics and if it has enough flow to work both. How to run the air not so sure maybe a belt driven compressor driven off the front of the motor.
I would appreciate all comments and advice. I am in the wheatbelt of Western Australia.
I have Trac 800 (1975?) with a dead OM314 motor and have the opportunity to replace it with an OM 352 from a Class combine harvester. I have a few concerns regarding hydraulics and the air compresor. I can fit the hydraulic pump from the harvester but not sure how to plumb the power steering and rear hydraulics and if it has enough flow to work both. How to run the air not so sure maybe a belt driven compressor driven off the front of the motor.
I would appreciate all comments and advice. I am in the wheatbelt of Western Australia.