25.07.2017, 22:49
Hello from Australia!
I have an MB Trac 1300Turbo and am getting it ready for a spraying job over our Summer.
I cant get the front wheel drive to engage. I have removed the air actuator, lubricated selector fork, replaced the O-ring on the selector piston and have 120psi (7-8Bar) at the actuator. When I turn the switch, I can hear a clicking in the actuator put still the front axle wont engage. Both diff locks work as normal.
Any ideas before I pull the gearbox out as a last resort?
Thank you for adding me to the forum.
I have an MB Trac 1300Turbo and am getting it ready for a spraying job over our Summer.
I cant get the front wheel drive to engage. I have removed the air actuator, lubricated selector fork, replaced the O-ring on the selector piston and have 120psi (7-8Bar) at the actuator. When I turn the switch, I can hear a clicking in the actuator put still the front axle wont engage. Both diff locks work as normal.
Any ideas before I pull the gearbox out as a last resort?
Thank you for adding me to the forum.