[optimog]

Hello Tim,

Crown and bevell gear is a matching set with one Number depending on the axle ratio.

There is a 27/7 Ratio (A 443 330 04 39) and a 25/8 Ratio (A443 330 05 39)

both were used only with the MB-trac heavy series BM443. They are not compatible with any Unimogs.

But "reproductions" may be available here in the Forum.

Check here: https://www.trac-technik.de/Forum/showth...?tid=28310&pid=172772#pid172772

but if you get lucky, only the splines from the driveshaft are stripped?

It is part number A442 337 00 10 but again was used only on these MB-trac.

best regards
Wulf