21.07.2021, 22:24
(Dieser Beitrag wurde zuletzt bearbeitet: 21.07.2021, 22:25 von Franz Josef.)
Hello Evan,
a very warm welcome!
You can see: it is possible to swap the engine from OM314-4 to OM352a-6 cylinders.
We have some discussions and postings here in the community about this.
In Germany this change is normally not conform with our legal requirements. Our TÜV = technical inspection agency is very strict.
Two points of this discussions I remember:
Because the engine is longer you have to enlarge the frame or replace the tank of the hydraulic system.
The higher torque of the OM352a is perhaps critical for the gearbox.
If you want to make the change, please give us many pictures.
In the internal section Das bin Ich ...
https://www.trac-technik.de/Forum/forumd...php?fid=12
you have the posibility to tell us something about you.
It is optional!
Your questions are welcome.
Best regards
Franz-Josef
a very warm welcome!
You can see: it is possible to swap the engine from OM314-4 to OM352a-6 cylinders.
We have some discussions and postings here in the community about this.
In Germany this change is normally not conform with our legal requirements. Our TÜV = technical inspection agency is very strict.
Two points of this discussions I remember:
Because the engine is longer you have to enlarge the frame or replace the tank of the hydraulic system.
The higher torque of the OM352a is perhaps critical for the gearbox.
If you want to make the change, please give us many pictures.
In the internal section Das bin Ich ...
https://www.trac-technik.de/Forum/forumd...php?fid=12
you have the posibility to tell us something about you.
It is optional!
Your questions are welcome.
Best regards
Franz-Josef